I. Replacement exolvuntur de oleum separationem filter ad Atlas Copco cochlea caeli compressors
Sub normalis operating conditionibus, commendatur ad reponere oleum separationem filter omnis 2,000 - 4,000 horas (referuntur ad apparatu manual in specifica details).
Si operating environment habet multum pulveris, altus humiditas, aut lubricating oleum qualis deteriorat cursim, postea cyclus debet breviabuntur.
Cumque compressa aeris continet nimia oleum (non est oleum strataks ad Gas Institit) vel pressura differentia ex olei Separator excedit 0.15 MPA (1.5 Bar), in filter debet reponi statim.
II. Praeparata ante replacement
Tools et materiae: praepara correspondentes originale officinas oleum separatione core (oportet aequare aeris compressor exemplar, ut GA, ZR series, etc), clavis, vastata oleum, continens pro colligendis oleum.
Tuto operatio:
Subsisto apparatus et interficiam off pelagus potentia copia, dependeat in "sustentationem in profectum" Monitum signum.
Exspecta ad unitatis ad refrigescant ad normalis temperatus, dimittere pressura in olei Separator tristique (aperire missionem valvae vel pressura release valvae).
III. Replacement gradus
Removere veteris oleum separationem Core:
Remove tegumento vel fixing fixis in summitate in oleum separator tristique (nam quaedam exempla, necesse est ut primum removere oleum pipe, pressura sensorem, etc).
Utere clavis ad PRAETORQUEO senex oleum separationem core (operari tardius ad vitare splashing RELICTUM oleum) et ponere in vasto oleum continens.
Emundare RELICTUM oleum et impudicitiis in piscinam, reprehendo si rubigo vel damnum in interiore muro lacus, et necessitate mundus vel reparare.
Install novum oleum separatione core:
Reprehendo si sigillum superficies novum oleum separationem core est integrum, reponere novum signantes gasket (applicare parva moles mundus lubricating oleum ut adiuvaret sigillum).
Tighten the new oil separation core according to the specified torque (refer to the equipment manual, usually 30 - 50 N·m), avoid loose resulting in air leakage or tight resulting in damage to the threads.
Restituo in reditu oleum pipe, pressura sensorem, etc, ut firmum et fideles nexu.
Reset et inspectionem:
Close de missionem valvae, operimentum olei Separator tristique operimentum et figere eam.
Connect the power supply, start the air compressor, observe if the operating pressure is normal, check if there is any air leakage or oil leakage at the installation position of the oil separation core.
Curre ad X - XV minuta, tunc reprehendo pressura differentia iterum (initial normalis pressura differentia sit ≤ 0.03 MPA), confirmare non abnormalities ante expletum replacement.
